07-14-2021, 06:48 AM | #177 | |
Private First Class
207
Rep 100
Posts |
Quote:
|
|
Appreciate
0
|
07-25-2021, 08:51 PM | #178 | |
Major General
7334
Rep 7,297
Posts |
Quote:
|
|
Appreciate
0
|
07-27-2021, 10:37 AM | #180 |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
+1 the axle back on it own is a major improvement over stock, but it sounds even better with the correct midpipe.
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
1
BMW DIY Guy3074.00 |
08-12-2021, 08:17 AM | #181 |
Private First Class
138
Rep 142
Posts |
AA EL Resonated mid pipes & AA valved exhaust
G’day mike@x-ph.com
Can anyone point me to an example of AA EL Resonated Mid-Pipes and AA Valved Rear Exhaust . I have a M2 Cs and I’d like to get feedback on that combination and any video . I do not want any raspy/metallic noise from the exhaust . Thanks Bruce |
Appreciate
0
|
08-12-2021, 09:04 AM | #182 | |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
Quote:
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
0
|
08-27-2021, 01:00 PM | #183 |
New Member
30
Rep 26
Posts |
AA New Valved Exhaust + AA Single Mid-pipe
I know I promised a few videos of my exhaust setup (AA's new valved exhaust + AA's Single mid-pipe) so here they are. Finally had the time to make them. Hope it clarifies your concerns or maybe bring more questions LOL!! JUST make sure you use a good set of headphones, otherwise you cellphone speakers will not replicate the nice deeper tone this setup have. I guarantee you its even a deeper tone if you listen it in person... but my aging Samsung S9 did a decent job recording these vids
Last edited by juanky84; 08-27-2021 at 01:37 PM.. |
Appreciate
3
|
08-27-2021, 01:07 PM | #184 | |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
Quote:
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
0
|
12-04-2021, 11:56 AM | #185 |
Second Lieutenant
89
Rep 273
Posts |
Can anyone provide me with assistance. Ever since installing Ive been getting a strange rattle under some conditions and I am having a hard time replicating it. I am 99% sure the remainder of this sound is still the axleback portion rubbing against the subframe of the car where the lower control arms lie. I managed to adjust a little and the noise is definitely less. However, this being said I am having a insanely hard time perfecting the fitment to get no noise out of it. Its often just a half second noise a couple of times per drive however I would still like to eliminate it. Anybody have tips?
|
Appreciate
0
|
12-09-2021, 08:27 AM | #186 | |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
Quote:
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
0
|
12-09-2021, 07:35 PM | #187 | ||
Second Lieutenant
89
Rep 273
Posts |
Quote:
|
||
Appreciate
0
|
01-04-2022, 12:27 AM | #188 | |
Private
125
Rep 97
Posts |
Quote:
Would really like to hear some more videos of this setup at higher RPMs etc if anyone else has this combo! Almost leaning towards pulling the trigger on AA single and the new valved backbox, other two options I am debating is Dinan or breaking the bank on a full Akra system... |
|
Appreciate
0
|
01-04-2022, 09:36 AM | #189 | |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
Quote:
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
2
CanadianComp125.00 BMW DIY Guy3074.00 |
01-04-2022, 09:43 AM | #190 |
Major
1103
Rep 1,263
Posts
Drives: 20 BMW M2C 17 Mazda MX-5 RF
Join Date: Oct 2006
Location: "Get Busy Living, or Get busy Dying"
|
I ran a AA Single with Wagner HF cats and the AA valved rear section on my 1st M2C
Its about a good as your going to hear unless you run with their new unequal length. I now have the new equal length midpipe with the valved rear on my 2nd M2C and its awesome! It now sounds like a properly inline 6 BMW should...
__________________
2005-2006 BMWCCA Boston Chapter president
2004 Mazda Rev It Up Finalist 2002-Present HPDE Instructor My 2020M2C Build: https://f87.bimmerpost.com/forums/sh....php?t=1696726 Last edited by SEAT TIME RULES; 01-04-2022 at 01:05 PM.. |
Appreciate
1
BMW DIY Guy3074.00 |
01-04-2022, 11:41 AM | #191 | |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
Quote:
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
0
|
01-04-2022, 12:25 PM | #192 | |
Private
125
Rep 97
Posts |
Quote:
|
|
Appreciate
0
|
01-04-2022, 01:06 PM | #193 |
Major
1103
Rep 1,263
Posts
Drives: 20 BMW M2C 17 Mazda MX-5 RF
Join Date: Oct 2006
Location: "Get Busy Living, or Get busy Dying"
|
Meant equal length with stock cats and rear AA valved...
__________________
2005-2006 BMWCCA Boston Chapter president
2004 Mazda Rev It Up Finalist 2002-Present HPDE Instructor My 2020M2C Build: https://f87.bimmerpost.com/forums/sh....php?t=1696726 |
Appreciate
0
|
01-04-2022, 09:52 PM | #194 | |
Lieutenant Colonel
968
Rep 1,900
Posts |
Quote:
__________________
Past: 1999 M3 2003 M5 2006 330i 2007 335i 2009 M3 2013 M3 2018 M3
|
|
Appreciate
0
|
01-05-2022, 09:38 AM | #195 | |
Brigadier General
3074
Rep 3,022
Posts
Drives: 2019 M2 Competition
Join Date: Jan 2017
Location: Maple Valley WA
|
Quote:
Its like 20 (f) degrees in the garage right now.. yoiks!
__________________
Check out my BMW DIY Channel on YouTube! E, F and G series projects from Active Autowerke, Bimmertech, Kies Motorsports, AvinUSA, Karbonius Composites and more!
** YouTube BMW DIY Guy ** 'Nimona' G87 M2 Build Thread 'Lillith' F87 M2 Competition Build Thread |
|
Appreciate
0
|
01-06-2022, 06:24 PM | #196 |
Registered
0
Rep 1
Posts
Drives: 2020 BMW M2 Competition
Join Date: May 2020
Location: San Jose, CA
|
I currently have the AA Single Midpipe and wanted to pair it with the Remus Sport Axle Back, but I too am wondering what it would sound like when paired with the AA Axle Back. Also, would it technically sound different than the AA Signature?
|
Appreciate
0
|
01-07-2022, 09:31 AM | #197 |
BimmerPost Supporting Vendor
24185
Rep 190,777
Posts |
It is at the signature and the valved use 2 different mufflers
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
11-28-2022, 07:35 AM | #198 |
Captain
1247
Rep 613
Posts
Drives: F87 M2 CS
Join Date: May 2019
Location: Erie, CO
|
After watching the below video a couple times, I became absolutely sold on the AA valved axleback, paired with the AA resonated equal length mid pipe:
Thanks to your Black Friday/Cyber Monday sale, I finally took the the plunge and ordered the combo from you guys. I can't wait to hear the difference over 100% stock.
__________________
Current: F87 M2CS - 6MT | Öhlins R&T | Garagistic Endlinks | Autosolutions SSK | AA EL Midpipe & Axleback | 255/275 PS4S
Gone: F87 M2C - 6MT | Öhlins R&T | G.C. Camber Plates | Autosolutions SSK | UCP | AA EL Midpipe & Axleback | Apex EC-7 | 265/295 PS4S |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|