[BE11MRB]

Anyone had any issues with controlling the exhaust valves as they don't move.

[Duke Silver]

I thought I was having the problem of only one valve working on my Remus exhaust, so I ended up getting a cgprecision controller to manually operate the valves. If you go down this route it connects at the 'Y' cable near bumper and not on top of the valves...

Also, even in different modes without the controller the valves will be open at idle, start-up and low RPMS.

[mike@x-ph.com]

If installed correctly, REMUS use the stock valves. They will function the same as they would on the stock exhaust.

If you want more control, we offer the VSC exhaust controller

[BE11MRB]

Originally Posted by mike@x-ph.com

If installed correctly, REMUS use the stock valves. They will function the same as they would on the stock exhaust.

If you want more control, we offer the VSC exhaust controller

I purchase the BMS CAN bus module because I know it is supposed to work via ECU valve control and they 100% do not move. I know this module is getting read from the car as the indicators flash as explained in the BMS manual.

Can anyone offer any assistance on what I'm doing wrong, unfortunately as I purchased the exhaust 2nd hand I got no manual with it but I looked straight forward.

The springs are Remus ones on the actuators the Y piece is brand new plugged in to both actuators and the car so I don't know what else could be stopping them from opening and closing, they are just always open....

Thanks in advanced