09-12-2022, 04:02 PM | #183 |
BimmerPost Supporting Vendor
3841
Rep 54,348
Posts
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com
|
|
Appreciate
0
|
04-11-2023, 12:41 PM | #194 |
Second Lieutenant
360
Rep 295
Posts |
Is there a "taller" top nut available for these Kline units? Could the lower collar area just be machined differently so that the hex area sat higher? I only have one box end wrench that is able to "grab" that top nut to tighten it. The nut sits low so that there is not a significant area available to mate with a wrench. I may try to find a few washers to fit underneath those top nuts. . I've also had these top nuts loosen..
|
Appreciate
0
|
04-11-2023, 07:47 PM | #195 | |
BimmerPost Supporting Vendor
3841
Rep 54,348
Posts
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com
|
Quote:
Anything custom you will have to contact TCKR for custom made hardware. |
|
Appreciate
0
|
04-11-2023, 08:34 PM | #196 |
Second Lieutenant
360
Rep 295
Posts |
This is on a 2017 ZL9 Performance Package m2 with the M Performance suspension. You can barely grab the top of that nut. Another 3..5 mm in height would be perfect.
|
Appreciate
0
|
04-12-2023, 11:44 AM | #197 |
BimmerPost Supporting Vendor
3841
Rep 54,348
Posts
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com
|
M Performance/KW isn't one of the fitments. If you somehow got it to work and need special hardware, contact TC Kline Racing.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|