[omasou]

Originally Posted by HFW003

These are the business, I have just ordered a set for mine

https://www.lakinplates.com.au/index...n=1&keyword=m2

OMG. Your kidding right a $100 for a bracket? BTW, that video was a joke. No one is stupid enough to screw a license plate directly into the trunk. At least I hope not.

You guys would cringe at my $4 PepBoy's frame.

[GoneIn4Secs]

Originally Posted by Tag

In my experience the OEM rear license bracket has always been problematic. Usually the screws get rusted and it's impossible to take them off. I've since started to put a little anti-seize on the screw before tightening it down. They stay rust free and come off as easy as the day you put them on.

But why did you need to remove the bracket in first place? Did you repaint/ppf the trunk?

[Tag]

Originally Posted by GoneIn4Secs

But why did you need to remove the bracket in first place? Did you repaint/ppf the trunk?

The frame partially covers up the license plate sticker so it's hard to get it off in preparation to put a new one on without removing it.

[GoneIn4Secs]

I think the OP talking about bracket that goes behind the plate and frame

[modeboy]

Originally Posted by omasou

The two holes in the car are a standard size and distance apart. Buy the Focus RS one and use it.

These all look similar to the BMW one on my cars. So I don't think they would be an improvement.

https://www.amazon.com/s?k=rear+lice...b_sb_ss_i_3_19

I just bought this one and the holes do NOT line up with my '20 M2 Comp. The holes on the bracket were just slightly narrower than the ones on the car, even with the wiggle room they gave you on one of the holes.

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

I too am looking for a higher quality bracket that fits, or at least one with machined screws for mounting the plate instead of those crappy ones that dig into plastic to screw in.

Jason

[Joaco135]

Just bought this one and the holes do lined up with my 2020 M2C

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

[modeboy]

Originally Posted by Joaco135

Just bought this one and the holes do lined up with my 2020 M2C

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

Really? On mine one of the holes was just slightly off. Strange.

[Joaco135]

Originally Posted by modeboy

Really? On mine one of the holes was just slightly off. Strange.

In this one the left hole is oblong a little to make sure both bolts go in straight.

[Zugspitze]

https://kliimw.com/collections/bmw

[modeboy]

Originally Posted by Joaco135

In this one the left hole is oblong a little to make sure both bolts go in straight.

Yea I had the same one with the oblong hole. Even with that it wasn’t enough to allow the holes to line up. Weird. Maybe I got a defective one. I’ll try again.