11-29-2019, 05:36 PM | #1 |
2018 BMW M2
230
Rep 149
Posts
Drives: 2018 BMW M2 - Widebody
Join Date: May 2018
Location: Pennsylvania
|
Shark Fin Antenna Assembly
Hey guys,
So I removed my fin to take the wrap off my roof, just have a couple of questions. What adhesive did you use to put it back on? And if it's 3m tape, what thickness? Thanks guys so much!
__________________
LLB Widebodied ///M2
Ordered 5/6/18(112) | Production Started 5/16/18(150) | Production Ended 5/28/19(155) | Transport to PoD 6/1/18 | On Boat to US 6/11/18 | Arrived in US 6/28/18 | Pickup on 7/3/18 My M2 Build Instagram: Ryder.m2 |
11-30-2019, 04:08 PM | #2 |
Captain
208
Rep 602
Posts |
I also used 3M and worked great. I believe it was the 1/8 thickness. You don't want it to stand proud between roof and fin. Hope it works for you. I did make sure all surface was clean...and made sure tape was cut to fit completely.
|
Appreciate
0
|
12-01-2019, 02:51 AM | #4 |
Major General
7246
Rep 7,422
Posts |
3M VHB 2 cm wide, and I cut it to size. In regards to thickness I have no clue because it only comes in one thickness, just variations in width. Just wrap it uniformly and at the same level around the edge of the antenna bottom to give it a good seal vs. water.
__________________
Click on the link below to see a compiled list of every review I have ever written:
https://f87.bimmerpost.com/forums/sh...2#post30368242 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|