01-03-2021, 12:27 PM | #1 |
New Member
0
Rep 5
Posts |
My ats has stopped working (reads -40) and needs replacing. Have purchased the new part and located the old one in the passenger side wheel arch lining but it's just hanging down and there doesn't appear to be anything to attach or slot it into. It can't be right that it just hangs so I'm thinking the 'clip' or holder, whatever it sits in has come off. I can't tell where though - does anyone know precisely where it's supposed to clip into?
I've been searching forums for months and there's no information on it! Attached are pics I've taken of where I think it should go (the hole) but there's no clip there. Thanks |
01-08-2021, 05:02 PM | #3 |
Second Lieutenant
174
Rep 218
Posts |
The clip the sensor hangs on will probably be difficult to access without pulling the fender liner back more. I think you will get better access by turning the wheels all the way to the right, just like your image from BMW TIS shows.
I also feel the image is misleading about where the sensor is located. When I unhooked mine before removing the bumper it seemed the sensor was farther forward and higher. Or maybe it just seemed that way because it is awkward reaching behind the bodywork. Good luck! |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|