09-26-2021, 02:18 PM | #1 |
New Member
39
Rep 22
Posts |
Full Front End PPF + Cereamic coating (need opinions on the quality of the install)
I got Stek PPF film installed on the full front end + side skirts
Looking at the front bumper I don't know whether I should be happy or have the shop redo the installation. Would love your guys opinions for those who have PPF on their M2c. I was told that the front bumper because of the curvature it can't be laid down without the cuts. |
09-26-2021, 03:54 PM | #2 |
Private First Class
195
Rep 183
Posts |
I have full STEK and the installer also had to cut some of the plastic by the middle grill sides due to curvature of the frown. It's hardly noticeable unless you really get up close. Installer said the M2C front is one of the most time consuming cars to PPF due to the many curves on the lower grills and the indents on the middle grill. He also said he will charge more next time he PPFs another M2.
BTW, Where did you get it done? |
Appreciate
0
|
09-26-2021, 07:21 PM | #3 | |
New Member
39
Rep 22
Posts |
Quote:
I guess I am just surprised because when they do car wraps they don't have to cut but I assume it isn't as thick of a film. My installer does this part-time, he belongs to a car group I am part of on Facebook. |
|
Appreciate
0
|
09-27-2021, 06:43 PM | #4 |
Private First Class
195
Rep 183
Posts |
Not the best pic from my phone, keep in mind these are about an inch or two away from the surface of the car. I can't see the cuts when I'm kneeling in front of car, I literally have to feel with finger where cuts are made.
I had it done over a year now and the front still looks good and clean - paint is well protected. ___ |
Appreciate
0
|
09-29-2021, 03:27 PM | #5 | |
New Member
39
Rep 22
Posts |
Quote:
The edges capture dirt which sucks and overtime will be more noticeable, I wonder if there is a way to clean that. |
|
Appreciate
0
|
10-28-2021, 11:30 AM | #6 |
Second Lieutenant
583
Rep 278
Posts |
Not an expert by any means but many, either themselves or going back to the person who did the work, just take a very sharp blade and simply skim the dirtied or lifted edges off over time. In most cases, this creates an insignificantly changed edge and looks brand new again. Certainly wouldn't do it often to eventually created a much larger uncovered area or more noticeable cuts.
__________________
2020 M2 CS - Misano Blue, DCT, CCB
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|