08-23-2019, 06:22 PM | #1 |
Banned
1448
Rep 1,414
Posts |
Rear Bumper Alignment
So I pulled back the rear bumper in order to replace the rear reflector. I can’t get it back up on the metal support on the part underneath the taillight. Any tips?
Okay, I found a video that helped me figure it out. I was able to mold the lip on the bumper so that it slid over the metal piece rather than under it. Here’s the video if anyone else has this issue: Last edited by 243Racing; 08-23-2019 at 08:19 PM.. |
Post Reply |
Bookmarks |
|
|