I looked at the AWRON before deciding on the AK MOTION Center Vent Display.
Its much less expensive and I'm very pleased with it. It was $385 shipped.
https://burkhart-engineering.com/epa...oducts%2F54486
It was easy to install, even though the directions were only in German.
Overview over the functions of the display:
(the functions depent on the motorization)
automatic and manual brightness control
full graphical touch-display (with 65536 colors)
freely selectable bootscreen
OBD2-blocker function (unlock with freely selectable code!)
enable diagnostic (OBD2) by DataDisplay
freely selectable color scale (e.g. oil temperature red, yellow and green)
torque compesation value (e.g. for vehicles with chip tuning or powerbox)
read and delete engine error code
adjustable shift light (shown on the display or/and flash on the instrument cluster)
save and reset max values
Delete - R (F-series without cat code)
torque
power
speed (possible to match with GPS)
water temperature
oil temperature
gearbox temperature (automatic and DKG vehicles. E-series and F-series)
battery voltage
boost pressure (actual value)
boost pressure (target value)
Wastegate positon
charge air temperature (IAT)
air flow
firing angle
ignition time
lambda value
rail pressure
fuel pressure
exhaust temparature (calculated)
oil pressure (F-series. E-series with external sensor)
DPF differetnial pressure
pressure before DPF
soot mass DPF
driven distance since successfull regeneration of DPF
timing 0-100
timing 100-200
timing 1/4 Mile
timing 1/2 Mile
timing 1/8 Mile
freely selectable speed and timing measurement
laptime (displays distance and time)
G-Force
enable burble (F-series)
activation and deactivation of Active Sound Design (F-series)
Flap control
activation of the speddometer needle when igintion on
optimal external sensorik (oil temperature, oil pressure, exhaust temperature, ...)
Dashboard with eight freely selectable values
activation and deactivation of DSC/DTC while starting the vehicle (E-series)
activation of relays: up to four relays can be controlled with the unit
Compensation of scaled maps (for N54, boost pressure > 1,5 Bar)
selecting language and units (englisch, german, italian, french, dutch, Bar-PSI, PS-KW, Lambda-AFR, °C-°F, etc…)
saving of the last four timing measurements
up to four freely selectable parameters which can be displayed in the flow diagram
freely selectable values which can be displayed as values or as bar diagram (up to three)
unit is updatable
HTH,
HAZMAT