Quote:
Originally Posted by saint3448
Anyone know if a DIY exists for this? Got a set shipped to me, but no instructions.
Thanks
|
Straightforward... Place a towel or something to collect the shavings.
1. Remove OEM rubber covers
2. Put on SS pedal rubber covers.
3. Drill pilot holes into the pedals (brake pedal probably needs a nice Ti drill bit since it's steel). Take rubber cap off again.
4. Brake/clutch: Start with 1/8 and finish at 5/32 drill bit...you can add another intermediate size in between if you like.
5. File the backs of the holes to smooth things out.
6. Put on the rubber cover, then steel one, then tighten it with the provided torx hardware.
7. Go pedal: clean it up to prep for the 3M adhesive backing on the steel pedal.
8. Stick it on and drill 3/32 holes in the plastic.
9. Tighten the gas pedal bolts in (no nuts for this one). Don't over tighten this since it's plastic.
10. Vacuum and clean up.