Quote:
Originally Posted by VTBoss302
Getting ready to install an Auto Solutions SSK and trying to figure out which hardware I'll need to replace
According to the TIS it looks like the flex disc can remain attached to the front of the driveshaft when removing
https://www.newtis.info/tisv2/a/en/f...ion/1VnYrsHP3W
If this is the case I'll need 3 of each of the following
Hex Bolts - 26117527475
Self Locking Hex Nuts - 26127536563
However, if the flex disc needs to be separated from the driveshaft I'll need 6 of each
Any thoughts?
|
The flex disc was left attached to the transmission in the install video earlier in this thread. I agree with you that NewTIS appears to leave the disc attached to the drive shaft side. Either way, it sounds like you would only need 3 sets of bolts/nuts unless you decided to replace the flex disc as well.