Quote:
Originally Posted by chief1richard
Yes removed flex disc and used low grade loctite to reinstall bolts but recommend getting 6 new nuts. Install was not difficult, just attention to detail. Take some pictures for ease of reassembly. Also drive shaft support remove and slide shaft out of way do not remove rear of shaft.
|
Getting ready to install an Auto Solutions SSK and trying to figure out which hardware I'll need to replace
According to the TIS it looks like the flex disc can remain attached to the front of the driveshaft when removing
https://www.newtis.info/tisv2/a/en/f...ion/1VnYrsHP3W
If this is the case I'll need 3 of each of the following
Hex Bolts - 26117527475
Self Locking Hex Nuts - 26127536563
However, if the flex disc needs to be separated from the driveshaft I'll need 6 of each
Any thoughts?