[M2guru]

Was swapping between track wheels and street wheels when I tightened the first rear driver's side to something less than my goal and the stud snapped off in the hub. I removed all the others on that wheel to check them out and they look good.

I am curious about two things: 1) anyone else deal with this type of thing? I've been wondering how much of a wear items these are. 2) How would you recommend getting the remaining stud out of the hub? All that's left is the threaded part that goes into the hub...so it looks like drilling will be best, but then what does that look like (guidance)?

Thanks in advance for your thoughts.