Well looks like my first attempt didn't go so well. It left me preferring a hard wired connection tbh.
I was having some initial connection issues (dropping out) and eventually realized the dongle was not firmly seated, presumably. I hadn't yet attempted to 'code' when all of this was happening. But when I went to code for the first time the connection died again! Afterwards upon reconnect the FEM module was 'unknown'.
I restored the very first backup with no connection issues thankfully but then the car shut off. I'm assuming this was normal since when I connected again, all modules were fine.
Needless to say, that was quite the scare!
What could be the worst that can happen? I'm assuming/hoping that so long as there is a viable back up we are pretty safe correct?
|