[vrooooom]

Got some more fluid and did the process shown on the YouTube video. After doing those push-in, open-close repeat a few times. A bottle of 355 ml later. Installed the clutch slave, went inside the car to test and the clutch goes to the bottom. I don’t know what’s going on.

The shop used a power bleeder type pumped to about 20 psi. Had the slave out. Each time rod was pushed and the bleeder was opened, a lot of fluid came out. We tried doing it w/o the power bleeder and I'd say a lot less were coming out.

This morning I tried it and half of the travel is soft. Back to square one.

Anyone?