Quote:
Originally Posted by dtmurf
Not a fun job but totally worth doing. I put a little extra sound deadening on the floor, not sure if it helped but it can't hurt! Did you do the filler pieces in the front fenders just in front of the doors? I think they make a difference too as the block engine sounds coming into the cabin.
|
I'd done those awhile back, definitely helped as well.
Quote:
Originally Posted by BMWF87Melb
good job! I'm looking to install the side plates (as taped to the body of the car) as per your first picture - would i just have to remove the side panels next to the back seat? Would i be required to take out the actual seats as well? were there any specific instructions to follow to remove those side panels?
|
for just the rear side panels, you would:
* remove rear seat bench (pull up at front edge, then out/away)
* remove side panels (5x plastic clips per panel, 3F 2R)
there was some info in the f22 thread I linked above, and I looked at a couple of youtube videos, but it was pretty straightforward. I didn't break any clips removing, but did on reinstall when I didn't have it lined up properly and went to pop it in. $3 and a trip to Autozone fixed that though.