Quote:
Originally Posted by F87source
Quote:
Originally Posted by ///M TOWN
Install the inlet
Best way to install it is to remove the PCV hose from the valve cover and pre attach it to the billet fitting that attaches to the inlet
Otherwise it's almost impossible to install because you cannot access one screw
With enough finesse I got it to fit together with the intake and have it situated so it's not really touch anything
Heads up MST pre installed the PCV fitting incorrectly causing it to be impossible to attach the set screw that holds it together
I am impressed so far
 |
with a 6" extension or a combination of a few othe extensions (i can't remember what I used) and a swivel join you can reach the t25 screw from near the heat exchanger to oil cooler line. Then you don't have to remove the pcv hose from the valve cover and risk snapping the tabs inside. |
Mine had a wiring harness, or some sort of a hose in the way, there's no way I could've done it any other way in my situation
Point taken though because those little tabs inside that sucker are very delicate