Yesterday I backed up a very tight concrete ramp and through a narrow garage door so I could throw my snow setup into the car (had it delivered to a warehouse at work). Car's ass was close to a wall and the parking sensors were going red and solid tone. Pulled it out of R and put it in neutral + handbrake so I could get out and check how much space I had, and continued hearing the sensor noise even after getting out (needed to make sure I had room to put a wheel in the trunk).
How do I check I-step, is that something I need to do in ESYS? I have the cable and app and all of that, but I still haven't had the time to sit down in the car and mess around with coding (been too busy with work and making space for this car in my cramped garage at home).
__________________
2004 Matrix XRS 6MT => 2008 VW R32 DSG => 2012 Audi TTRS 6MT => 2018 BMW ///M2 6MT
I'm an IT guy by trade and tech nerd by choice.
I like HPDEs, parts of US Hwy 129, NC 28, and the Cherohala Skyway.
I'm also a fan of aural pleasure.
|