Quote:
Originally Posted by Nezil
I was asked on another thread for the torque settings for the nuts and bolts required for the DP install, so here they are, taken from ISTA+: - Underbody panelling (self tapping screws): 3 Nm
- Downpipe to Exhaust V Band Clamp (Should be replaced): 30 Nm
- Downpipe to Turbo V Band Clamp (Should be replaced): 13 Nm
- Exhaust system mid point mount to cross member (E10 Bolts): 28 Nm
- Stiffening Plate to Front Axle (Should replace all bolts - see post above): 56 Nm + 90 degrees
- Downpipe mounting bracket: 28 Nm
- Oxygen Sensors: 50 Nm
I think that's everything. Let me know if there is something I missed. |
Great! Thanks for these. The only one I'm not sure which one it is is the one you call "stiffening plate to front axle". Interestingly I found this guide for Akrapovic and all the values are different for some reason:
https://d1sfhav1wboke3.cloudfront.ne...c329e97cb8.pdf