Quote:
Originally Posted by bdon_
So, I installed the switch, which works great, and then the next day I flashed the whole car to the latest I-Step firmware with esys and apparently this was fixed in software. By default it now shuts off the camera and stops beeping immediately upon pulling it out of reverse (manual in my case).
Tomorrow I'm going to see if I can code the camera to stay up longer so I can watch as I pull forward over/into parallel parking brackets, like before.
Updated car from I-Step F020-17-03-505 to F020-17-07-507
|
Interesting, I have a 2018/LCI and mine will continue to beep even when put into neutral. Have to go into 1st and move a bit before it shuts up.
I want to know if it's possible to use the button to enable the camera even when not reversing. I can press it while driving forward, and the parking sensor screen comes up, but the camera is disabled. I can use the iDrive knob to try to enable it, but it doesn't work.