Quote:
Originally Posted by Fenix604
I will try to find shorter screws, I don't want to put a frame around it but that would take up the excess length. In the meantime, I used some double sided tape to add some length to the rubber bumpers and placed it just below the screw. As long as no one gives bumps it, it looks like it should be OK.
|
These M6 x 8mm (with 1.0mm pitch) screws were the shortest ones I could find:
https://www.ebay.com/itm/6mm-M6-x-1-...53.m2749.l2649
For each screw, I am using two M6 nylon washers that are 1.5mm thick, between (1) the screw and the plate and (2) the plate and the Carbonio mount:
https://www.ebay.com/itm/U-S-Seller-...53.m2749.l2649
This way, there are no excess lengths at all. I then added silicon bumpers behind the top screws, so that there is no hard contact with the bumper.
So much work for for a damn license plate mount