[Pparana]

I have another thread on here about the bearings failing on the ground control plates. GC did send me two new bearings so I did install with new dust boots.

I even removed my m3 LCAs and put on the stock ones. Install was with dinan springs and bump stops. Springs installed to dinan specs, I also verified orientation w dinan to be sure, but its very easy (I have swapped springs, shocks you name it since I was a kid)

Bearings both failed again, within 50 miles. Pictures will be posted below, below.

If you run these I would get them checked out. This type of failure will not be noticeable to most until catastrophic.