I'm still a few weeks from my parts from Aquamist arriving, but I'm starting to either receive, or get shipping confirmation on some other parts that I've ordered:
- 1 Gallon empty bottles for mixing water & meth - 2 ordered from Amazon
- 1/8" split ribbed tubing for under hood cable tidying - 10' Ordered from Amazon
- EWG Male and Female connectors - 5 sets of each ordered from AliExpress
- TMAP Male and Female connectors - 2 sets of each ordered from AliExpress
- Injector Male connectors - 1 pair from a Mini heated windshield washer harness ordered from eBay
- Injector Female connectors - 5 sets ordered from AliExpress
- 6mm carbon fibre braid - 4m ordered from eBay
- 4mm carbon fibre braid - 3m ordered from eBay
- 6mm PTFE tubing - 10' ordered from Amazon
- Fuel Rail Pressure Sensor Male & Female connectors - Ordered from BMS (as their Flex-fuel harness)
- Glue filled heat shrink tubing - Ordered from Amazon
I've also started designing / building a more elegant fail-safe, which will reduce boost by biasing the MAP sensor output voltage high after 5PSI of boost. This will require testing to validate, but should not result in a CEL or limp mode like the current suggestion of sending 5v to the EWG sensor wire currently would.
... More to come!
__________________
2018 ///M2 LCI, LBB, 6MT...
Current Performance Mods:
CSF FMIC, ER CP, Fabspeed Cat, Aquamist WMI, GFB DV+, NGK 97506, BM3 (Stage 2 93 OTS), CDV delete, UCP, M2C/M3/M4 Strut Brace, M3/M4 Reinforcement Rings