Quote:
Originally Posted by Poochie
The idea of Brake Force Display is it only activates when the ABS kicks in, for real aggressive braking. Think of your cell phone flying off the seat when you brake hard, something like that would activate it.
Anything else would just annoy fellow motorist behind you and which I believe is illegal in most US states because brake lights have to remain steady burning, under DOT rules.
If you want to adjust it to the most sensitive setting, code the parameter I listed below under the FEM module.
|
Quote:
Originally Posted by chmura
Quote:
Originally Posted by Poochie
The idea of Brake Force Display is it only activates when the ABS kicks in,
|
Not sure this is true. I have it enabled to the most sensitive setting and it comes on when I hit the brakes hard, but not that hard to activate ABS.
I had it on medium setting and it never came on. So I changed it to the most sensitive setting. I do not want it flashing at every stop sign. But I do want it to flash when I get the brakes hard. I found the sensitive setting to be ideal since you still have to press the brake very hard to activate the flashing.
|
I should of instead stated "or
when the ABS kicks in"
I don't know what to tell you then, code what works best for you.
What's funny is the medium and hard setting is basically the same (wert 2 & 3) because when you convert "0A" in hex value it's "10."
: