Quote:
Originally Posted by chief1richard
Installed an Autosolutions Shifter last year, and was considering installing this bushing as it would require only removing 2 small screws to slide bushing on to shift assembly. Decided not to do it as I did not think it would do anything after laying on my back looking at the assembly. The hardest part of doing this is clearance under car if you don't have access to a lift. I used a Quick Jack which was better than Floor Jacks. It is not hard at all to do, just limited access under car and removing shields. Would probably have done it if I didn't do the Auto Solutions Shifter.
|
did you drop (or partially drop) the drive shaft?