Quote:
Originally Posted by Lucho13
|
I used the same guide, and actually found a couple of the later posts even more helpful. Overall it was very easy, other than the fact that I sliced my finger wide open on the edge of the brake pedal cover. Those things are thin, and apparently pretty sharp!
What I found most interesting, though, is that my brake pedal wasn't at all like all the ones I've seen pictured. They all appear to be thick, flat, hardened steel, which everyone says is fairly hard to drill through. Mine was a relatively thin steel, but it was ridged, almost corrugated, for strength. It was actually easy to drill through, and it just happened that all of the bolt holes were in the "valleys", which made it easy to get the nuts attached on the back. Not sure it would have been possible if they'd been in the "ridges". I wish I'd taken a picture when I had the cover off, since it's a pretty interesting difference.
Just something to keep in mind.