Quote:
Originally Posted by tom @ eas
Quote:
Originally Posted by detroitm2
I should clarify, everything works. I just get a battery warning.
|
It's likely the SOLO2 keeping CAN alive, it should be cutting the device when power is switched off.
I would recommend contacting AIM to notify them of the issue, or possibly look into a 12V 2 channel relay to cut the CAN lines when ignition is off in the meantime if you want to leave the SOLO in the car. There's a ton of them on eBay that are relatively inexpensive. |
This was my plan anyways. It's not permanently installed, but I have a 4 pin connector wired up so I can just plug and play when I go to the track. I can connect a 12v relay behind that to kill the canbus when the 12v signal is lost.