AIM Solo 2 DL causing battery discharge warning (CANbus)
I noticed this a while back when I installed my Solo 2 DL, figured I'd ask around and see if anyone had any thoughts.
Long story short, I installed an AIM Solo 2 DL unit in my car, which is hardwired to the canbus, and power is hardwired to a switched power source in the trunk.
Whenever I shut my car off, the Solo will turn off shortly after since it's on a switched power source. However, when I start my car back up, I get a warning about battery discharge while stopped.
It's worth noting that this same error came up even when I ran the solo 2 off its internal battery power, and not wired up to the car.
It's almost like it's drawing power from the canbus and the car doesn't like it.
The only solution I've found is to disconnect the cable from my solo when I end a track session.
Anyone have any thoughts on this? I know there's only a few people here who are running the solo DL with a direct canbus connection, but thought I'd ask anyway.
Thanks.
|