Today I swapped the carbon trim on the center console. When installing the reversing camera, damage occurred. One may call me petty, but I look there every time to check whether it has gone away by itself. No chance, is back there every day.
If someone has to change it, here is an explanation how it works:
The aperture is only inserted and can be pulled out.
1. Fold up the middle armrest
2. Press on the side where the carbon strip rests against the armrest. By the pressure it rises.
3. In the resulting gap (from the passenger seat side) put a wedge and pull off the cover upwards.
4. Disconnect the cable of the controller if desired (I have not done) and the 3 Torx screws on the back.
5. ... the whole process backwards and done!
It takes about 10 minutes.