Quote:
Originally Posted by Japper69
Just got around to carrying this retrofit on my pre LCI M2. Took off the original lights but in addition to the 8 pin plug connector I unclipped I also have a two pin connector on both lights that goes to a sensor ( I think ) that is inside the cluster. I have the official BMW retrofit instructions and no mention of this.
Do I just tape this up as there is no location for it on new clusters ?
View post on imgur.com
|
Those two extra colored wires are for the brake light. You don't need them. Cap off the tips with electrical tape and wrap it around the original cable. See my pic below of my tail light mapping.. Top photo(left) & bottom photo (right).
Those [COLOR="DarkOrange"]brown[/COLOR] wires attached to the harness are for the Pre-LCI taillights [COLOR="DarkOrange"]only[/COLOR], you don't need them in the LCI tail lights. Long story why..
The link below should help also. Good luck
DIY: LCI Tailights
https://www.2addicts.com/forums/show....php?t=1405431
Possible coding issue:
https://www.bimmerpost.com/forums/sh...php?p=23338945