Quote:
Originally Posted by jmh600cbr
Quote:
Originally Posted by andrewc89
Quote:
Originally Posted by evilIu4
wondering what would it take to code VLD on my LCI
I already have bimmercode and hesitant to go about coding with e-sys.
|
VLD with bimmercode:
Front Electronic Module > Expert Mode >
3073 LaMaster1 > LUT_FLC_FORWARDLIGHTING_Y > 9C,9C,9C (Both)
3073 LaMaster1 > C_AFS_ENA > Enable (Both)
Note: You'll see two check marks. If you tap the top one, the bottom one will go away. Make your selection. Back out. Go back in. Both correct selections should have the blue check mark next to them.
Quote:
Originally Posted by Perp
I'm guessing you need adaptive option to get VLD working?
|
yes |
Thanks for this. How will I know it worked? |
Set the lights to auto in your garage or facing a wall when it's dark out. Turn the car on and then pull the high beam lever. You'll see the drivers side beam move left to right every time you switch from low to high.