I'm at a loss as well, been chasing this for over a month now.
Wife has a 2018 M2.
Setup:
Vorshlag Camber Plates
Ohlins R&T with the plastic spring seat washer on the bottom and rubber spring washer at the top (all included parts)
Low speed the driver side seems to be clunking.
I've already tried a few steps:
-Remove endlinks, still had noise.
-Retorqued everything including arms and set load on arms
-Reassemble everything by disassembling.
-Swap sides (ohlins pass <==> driver but same camber plate but no endlinks)
All have been failures to remove the knocking on the driver side.
One note: full stiff setting on the Ohlins, altered the noise pitch/loudness but it was still present.
I think tomorrow I'll try using the stock shock to see if that eliminates the noise.
I'm stumped!
|