View Single Post
      04-21-2019, 07:30 PM   #23
Craig8
Enlisted Member
Craig8's Avatar
196
Rep
37
Posts

Drives: M2C, RS3, R8 (gen 1)
Join Date: Nov 2015
Location: Toronto

iTrader: (0)

I wanted a spoiler with an interesting shape (i.e. notch in the top and bottom) so choices were limited. This was $300 so I took a chance on it.

The overall quality of the weave/finish is pretty good. Fitment is "ok" - you can't really see it but the center area curves up a couple of mm higher than the ends so the 3M tape is not making contact with the trunk in the center area. The spoiler is on solid however and doesn't move when pushing against it.

When installing, I'd recommend paying careful attention to how well the contour of the spoiler matches the contour of the trunk where you apply the 3M tape. If I were to do mine over again I would have put a 2nd layer of tape in the center area.
Appreciate 0