Quote:
Originally Posted by bentom2
Next up is engine mount inserts. The fluid in the left side mount liberated itself at some point, so I need to replace them anyhow. I went with the ones from Bimmerworld, but Vargas makes them too. I looked for solid rubber mounts, but no luck. I definitely am not going to jump to urethane (the only other option I found) as I still drive too and from the track and on the occasional backroad.
I’m hoping these inserts prolong the life of the hydraulic mounts and stiffen things up just a bit at the same time, without adding too much NVH. Will report back when installed.
|
How do you like the stock mounts + metal inserts? Noises at idle? One would think the addition of the metal insert would add a lot more noise.
I just purchased the Revshift 95a mounts, but if the stock mount + insert combo is that good I may switch.