Quote:
Originally Posted by F87source
Quote:
Originally Posted by Westersund
Complete kit with the added, free of charge, hose holder for the control arms/uprights.
Hose holder for the uprights, to minimize the wear on the hose you can add some "padding" on the edges.
Hose holder for the control arms that uses 2 of the zip ties for the ducts.
Didn't install the backing plates on my car since this was only temporary for test fitting purposes (hose routing). Ideally you can use a hose clamp on the hose holder on the upright instead of a big zip tie I used, since it was only temporary.
Full lock to the left. The car is lifted with a jack so it's tighter between the control arm and the sway bar than when the car is on the ground (Correct me if I'm wrong).
Full lock to the right.
 |
Very very nice.
Btw where is the air ducted? To the disc surface or to the hat? Because you need to duct air into the hat so that the disc doesn't get cooled unevenly and crack.
https://www.essexparts.com/news-blog...n-my-track-car |
Also curious, it'd be better if he can show a picture of rotor with shield installed