Quote:
Originally Posted by as7920
Quote:
Originally Posted by Wilsm2
Hi
I did put some info at the beginning of the thread, i hope this helps you more.
I pushed the trim tool in the gap of the trim and the DCT gear leave (red arrow) on photo , you will see the front of the trim bend up and un hook.
|
I managed to fit that part OK. In fact that was the easiest of the three. Although my new part isn't as flush as my old one was on the M135i.
I'm struggling with the black plastic trim with the M logo on it in the centre of the shifter. It's not shifting 
Quote:
Originally Posted by omasou
NO! Use dental floss.
|
I saw that tip too, in fact I'll try that first. |
I used edge of a trim tool, once I got the edge of the black trim I just rocked it up and down gently ( like moving a loose tooth lol) what would help is use a hair dryer first to warm up the gear leaver to loosen up the M3 tape.