Quote:
Originally Posted by Prodigy.
Installed my kit today, DIY was a great help, used dental floss to get the DCT sticker off, thanks for the tip on using thread or similar.
Anyone else have the issue of the DCT sticker not sitting quite as nice and flush on the c/f knob as the oem one. Mine appears to sit up slightly higher on one side than the other, as if the cut out is just fractionally too small, no biggie though, still love it over the factory trim.
|
I dry fit mine first using the original insert and noticed that it didn't sit right until I lined it up better and pushed it down well. I then used woodturing double sided tape to reinstall, instead of using the replacement insert that came w/the kit just to see if it worked. It did. So I would remove it, test fit then reinsert.