10-31-2017, 02:07 AM | #1 |
I INDIC8
612
Rep 1,286
Posts
Drives: 2018 LBB M2, 6MT
Join Date: Dec 2016
Location: Cleveland, OH
|
Getting wires through the firewall?
See subject - anybody know of a good place to get through the firewall with new wires (for a concealed radar/lidar system)? Or for a boost hose to run a manifold-based boost gauge?
__________________
2004 Matrix XRS 6MT => 2008 VW R32 DSG => 2012 Audi TTRS 6MT => 2018 BMW ///M2 6MT
I'm an IT guy by trade and tech nerd by choice. I like HPDEs, parts of US Hwy 129, NC 28, and the Cherohala Skyway. I'm also a fan of aural pleasure. |
10-31-2017, 02:25 PM | #3 |
I INDIC8
612
Rep 1,286
Posts
Drives: 2018 LBB M2, 6MT
Join Date: Dec 2016
Location: Cleveland, OH
|
I haven't even gotten under the dash yet to look at stuff, but I hope that works... my car has a clutch though so I'm thinking that spot might already be filled?
Looking for DIYs on dash disassembly as well...
__________________
2004 Matrix XRS 6MT => 2008 VW R32 DSG => 2012 Audi TTRS 6MT => 2018 BMW ///M2 6MT
I'm an IT guy by trade and tech nerd by choice. I like HPDEs, parts of US Hwy 129, NC 28, and the Cherohala Skyway. I'm also a fan of aural pleasure. |
Appreciate
0
|
02-18-2018, 01:34 PM | #6 | |
Major
633
Rep 1,083
Posts |
Quote:
Which fuse location did you use? Where does the cable end up inside? |
|
Appreciate
0
|
02-20-2018, 09:06 PM | #7 |
Enlisted Member
41
Rep 33
Posts |
I used fuse 146 in the trunk. Ran a wire back and used a fuse tap. As for the cables pull the trim panel under the dash on passenger side. There is some insulation that the hole is behind. Push the cable through and it should start showing. I used a guide wire taped to the cable. I'll try to get pics.
|
Appreciate
1
voyagergab633.00 |
02-20-2018, 09:11 PM | #8 | |
Major
633
Rep 1,083
Posts |
Quote:
So you wired somethings to both truck and engine bay fuse boxes. |
|
Appreciate
0
|
02-22-2018, 08:39 PM | #9 |
Enlisted Member
41
Rep 33
Posts |
|
Appreciate
1
voyagergab633.00 |
Post Reply |
Bookmarks |
|
|