Just put my set on. Install was fairly easy. 3 8mm bolts in the wheel well (I recommend removing the wheel for this). 2 8mm bolts under the rear bumper. Then pull the lining back and remove the bolt holding the rear bumper on (I believe it was a T19-T22). Then pull back the wheel arch liner and and pull back the bumper and you should be able to see the back of the rear reflector. I then taped the outer side of the bumper with some blue painters tape and jammed a soft bondo squeegee between the reflector and bumper to put some force on the reflector. Then going back inside to the back of the bumper use a pair of pliers to squeeze the tabs top to bottom (of the 3) and the reflector should fall out. Work the squeegee down the face of the bumper to apply some pressure and repeat until reflector is out. Then snap in the new reflector and you are done. Turned out great in my opinion. Thanks
Acexxon for putting together such as trick part. Loving it!
