Quote:
Originally Posted by dvas
Anyone running square 275/35/18 Nitto NT01s on 10 inch wheels?
I was hoping to squeeze this setup in without spacers on a set of 18x10 inch wheels from Apex but fit may be aggressive. Would prefer to run without a spacer but will put one on if needed. Possibly ET 33 or 25? My car is lowered on Bilstein PSS10s with GC camber plates up front, so I have some adjustability.
|
That shouldn't be a problem! The only spec you need to really look at is the front offset. With a ten, depending on your strut et23 and below is the sweet spot with camber plates. With a 275 in the rear a good fit would be et28 and above.
The et33 will be fine on the rear. The et25 would be cutting it close, it may be perfect in the rear but NT01's run wide. so the only spacer needed would be in the front if you buy et33 square.