Quote:
Originally Posted by M2guru
As I work to change motor mounts, I am wondering if anyone has changed motor mounts by simply lifting the engine up. It seems that there is barely enough clearance - barely meaning not really enough. I am not sure I trust my Harbor Freight engine support bar to hold all that weight. I already bent one of the tabs on the support bar. Right now I am thinking that I'll try to jack up from the bottom along the oil pan to block edge while I use the engine support bar, but I am not sure how that will go. I don't have an engine hoist (yet)... I would appreciate any thoughts on this.
|
We used an engine support bar and a jack under the trans bell housing. If you unbolt the engine mount bracket from the block, you can get the mount out without dropping the subframe.