Eventuri Carbon Fiber Engine Cover for the BMW M2 F87
I picked this up from the team at
IND not sure if it's on the site yet but I believe they have them in stock.
Everyone can use more carbon fiber.....
Items that you will need - BMW Logo - part # 11 14 7 788 967 (this is not the same part number on our BMW M2 Engine cover)
You will also need to pull the rubber grommets (total 3) out of the oem engine cover and put them into the carbon fiber cover as well as the insulation. Pics below.
Since I'm a bit ocd I went ahead and used the
Rupes Ibrid Short Neck with the Rupes Yellow Pad and Jeffscar Micro Finishing Polish (coming soon) to remove some of the hazing left behind from possibly the wetsanding and compounding after the clear coat was sprayed. I went ahead and polished it out to remove the haze and bring out the shine. Following it with 2 layers of Nanolex SI3D HD ; )
Haze on the CF Engine Cover
Polishing the haze out
I opted to remove the Eventuri decal.....
Probably should have removed them first before polishing
BMW Roundel Emblem
Used Nanolex EX to prep the CF Engine Cover for Nanolex SI3D HD
A nice thick coat of Nanolex SI3D HD goes on
After
Swapping out the grommets and insulation from the OEM Engine Cover
OEM Engine Cover
Back of Engine Cover with Rubber Grommets and Insulation
Pulling out the insulation from OEM Cover
Back of the CF Cover
Installed rubber grommets
Without insulation
Before with OEM Engine Cover
Eventuri Carbon Fiber Engine Cover
